(annyi időm nincs, hogy mindent két nyelven írjak meg, ez az angol nyelvű blogon jelent meg)
A szakszerű megoldás persze az lenne, ha minden esetben a kapcsolót tartalmazó teljes panelt cserélnénk – de részemről maradnék az alkatrészcserélgetés helyett a javításnál. Ha már javítás, akkor természetesen nyomógombcsere…. csakhogy: létezik olyan kapcsoló, amit nem lehet beszerezni, ráadásul a fólianyák forrasztása azért nem veszélytelen. Ebben a konkrét esetben például értelmetlen lett volna kicserélni, mert csak annyi történt, hogy az érintkező lemezke oxidálódott, ezért nem érintkezett (de nem volt eltörve).
Így aztán javítás lett belőle.
The sick camera was a 550d. No second contact on the button (practically, You had to push it very hard).
After disassembling, I have found out that this is a new type of button (new for me), one side a little bit larger than the other. I decided to disassemble it, to see at first, what the problem is.
The contact plate is in fact formed of two similar plates – and the lower one, which is responsible for the contact has a darker colour – some oxide or what on the surface. They had NO BREAKAGE, NO sign of mechanical wear, so I reversed them. Fortunatelly the cap is a remountable one. After assembling the camera, everything was OK again.
As a conclusion, I advice You, that case the button is OK, but only is perfect, don’t desolder it and build in a new one, just clean it from oxides, as the flexible cable is not for many resolderings. In this cases the button can really be repaired.
2 Responses to Expógomb javítás vagy csere – 550d